Harley Davidson Exhaust Nut Torque

Captive swivel extension with 12 inch drive. Retain exhaust flanges and mounting hardware for later installation. First you should pre-load the bolts to about 16 foot-pounds.

harley davidson jd engine harley davidson jar harley davidson jacket sale harley davidson jacket road warrior 3 in 1 green harley davidson jean jacket amazon harley davidson jeans uk harley davidson jacket used harley davidson jacket vanocker

Torque Specs For Exhaust Studs Harley Davidson Forums

Exhaust Header Torque Settings Harley Davidson Forums

Black Loose Cannon Slip On Muffler Brand Firebrand Year Make Model 2015 2017 Harley Davidson Harley Davidson Pictures Harley Davidson India Harley Exhaust

2016 Harley Davidson Street Glide Torque Specs

04 Dyna Engine Install Torque Specs Harley Davidson Forums

38 - 33 ft.

Harley davidson exhaust nut torque. Do initial loosening and final tightening while on side stand. Clicking this will make more experts see the question and we will remind you when it gets answered. Tighten the cylinder head flange nuts to the torque specifications listed in the Service Manual.

Tighten top nut to 9 - 18 in-lbs tighten bottom nut to 100 - 120 in-lbs Re-tighten top nut to 100 - 120 in-lbs Repeat on the rear exhaust. 516 - 19 ft. Tighten the exhaust flange nuts evenly and to a torque of 60-80 inlbs.

Axle Nut Torque Adapter For Harley-Davidson Replaces OEM HD-47925. These are brass high nuts U can get them for about a buck or so a piece. Route the oxygen sensor wiring back to their respective plugs and secure with wire ties as necessary.

2002 Later 95 - 105 Ft-Lbs 2001 Earlier 50 - 55 Ft Lbs. Step 6 Raise the exhaust pipes back up and thread the head bolts and rear mounting bolts into position. Harley Davidson 65184-02-7593 Exhaust Flanges Nuts Torque Cones fits model.

Expert Gear Advice From Riders. This swivel extension and socket combination allows you to easily reach the rear axle nut. Tighten the collector heat shield clamp.

Dyna Sportster Softail Touring. Additionally tighten the head pipe support bracket bolts as indicated in the exhaust manufacturers instructions. See the service manual.