Harley Davidson Exhaust Flange Nut Torque
For model frame code install the megaphone mounting bracket 676-P with grommet to the megaphone with two 516 flange bolts and dog bone nut plate supplied.
Harley davidson exhaust flange nut torque. Again use care not to scratch. Install lower nuts to 9-18 in. Tighten the exhaust into place.
Expert Gear Advice From Riders. Good thing cause it had over full turn. Fastener Size - Torque ft.
Route the oxygen sensor wiring back to their respective plugs and secure with wire ties as necessary. Expert Gear Advice From Riders. Assuming your using new gaskets you might want to repeat a second time.
Repeat steps i-iii for the rear cylinder exhaust flange nuts OR OR Muffler Bracket Bolt. This might be a bit high but because it is a steel stud in an aluminum head it could serve as a guide to a maximum limit. The nfieldgear catalog says the correct torque is 4 ftlbs 48 inlbs.
Tighten lower nuts to 60-80 in. Tighten the bottom nut of the same flange to 100 to 120 inch-pounds. Install upper nuts finger tight.
Im going to fit a Muscle. Repeat these steps for the rear cylinder head exhaust flange. Ad Fast Free Shipping on Orders Over 40.