Harley Davidson Exhaust Bolt Torque

RINEHART exhaust system you should seek the advice andor skill of a professional mechanic. In increasing number sequence 1-2-3-4 tighten the head bolt in four stages. First you should pre-load the bolts to about 16 foot-pounds.

harley davidson road glide horn cover harley davidson road glide for sale south africa harley davidson road glide gas tank harley davidson road glide stage 1 harley davidson road glide radio harley davidson road glide special handlebars harley davidson road glide police harley davidson road glide stage 4

Torque Specs For Exhaust Studs Harley Davidson Forums

Exhaust Header Torque Settings Harley Davidson Forums

Need Some Torque Specs Harley Davidson Forums

Torque Specifications Motorcycle Powersports News

Vance And Hines Eliminators Torque Specs Harley Davidson Forums

2016 Harley Davidson Street Glide Torque Specs

I would tighten the TORCA clamps to 45-60 ft-lbs.

Harley davidson exhaust bolt torque. Front Intake is Yellow. Rear Intake is Blue. The torque values I found for that size thread gives 8 ftlbs for a steel to steel interface.

Insert the Torque Cones. This might be a bit high but because it is a steel stud in an aluminum head it could serve as a guide to a maximum limit. Today Doc Harley explains the importance of checking the torque on your exhaust bracket boltsharleydavidson torque motorcycles.

Route the oxygen sensor wiring back to their respective plugs and secure with wire ties as necessary. I hope I explained this where you can understand this. Fastener Size - Torque ft.

4 Tighten each bolt to 38-42 foot pounds of torque. 3 Tighten each bolt to 22-25 foot pounds of torque. Repeat on the rear cylinder.

You may have to remove the heat shields in order to access the bolts on all the flanges and use antiseize compound all that heat and corrosion will make things tough the next time. 96 - 120 lbs. Axle nut is set at 50 FOOT lbs.

Gaskets are soft and can squish into the port area if tightened too much. Not to mention the pain in the azz if you snap a stud off in the head a few years from now. Front Exhaust is Green.